P/N 00141398 is the 88mm SIPLACE SmartFeeder X configuration with Splice Sensor. With a module width of 105.2mm and a requirement for nine feeder locations, this is not simply a wider version of a standard feeder. It directly affects feeder-table planning, available machine positions and the material setup on a SIPLACE X-Series line.
The feeder supports transport increments from 4 to 96mm in 4mm steps and tape height up to 25mm. These values matter when matching large carrier-tape pockets and components that require an 88mm material format. If the actual application uses 72mm tape, the 00141397 72mm Splice Sensor feeder is a separate configuration and should be evaluated instead of choosing by feeder appearance or overall size.
Wide-tape problems should be separated from true feeder faults before replacement. Start with reel alignment, carrier-tape tracking, cover-tape pull, splice-joint condition and programmed pitch. With an 88mm tape path, misalignment or uneven tape handling can affect the pickup position across a large material format, so the feeder or Splice Sensor should become the main repair target only after these setup conditions have been ruled out.
Because this feeder occupies nine machine positions, replacing it with an incorrect width or feeder configuration can affect more than one material slot in the line layout. Other SIPLACE feeder widths and sensor configurations can be compared in the ASM SIPLACE feeder range.
00141398 88mm X SmartFeeder Specifications
| Base Part Number | 00141398 |
|---|---|
| Known Revisions | -01, -02 |
| Part Type | SIPLACE SmartFeeder 88mm X with Splice Sensor |
| Assembly Level | Complete feeder |
| Tape Width | 88 mm |
| Module Width | 105.2 mm |
| Feeder Locations | 9 |
| Transport Increment | 4–96 mm in 4 mm steps |
| Maximum Tape Height | 25 mm |
| Sensor Configuration | Splice Sensor |
For matching, provide the complete 00141398 label and suffix, exact machine model, 88mm tape pitch, tape height or pocket requirement, confirmation that the Splice Sensor configuration is required, and clear photos of the installed feeder, reel and identification label.
A correctly matched spare has particular value at an 88mm position because the feeder occupies a large block of feeder-table capacity and may support a material format that cannot be temporarily replaced by a narrow feeder. Keeping the correct 88mm configuration available can reduce sourcing and reconfiguration time when the operating feeder has to be removed for service.
We can help verify the feeder P/N, suffix, 88mm material requirement, feeder-table position and Splice Sensor configuration before quotation. Return/exchange support and part-specific warranty terms can then be confirmed against the exact feeder supplied.