P/N 00141375 is the 44mm feeder in the SIPLACE X Smart family. For a line already equipped with X feeders, this identity matters more than the 44mm tape width alone because other 44mm feeder families also exist for SIPLACE equipment.
If 44mm material begins feeding inconsistently, first check reel installation, tape tension and routing, cover-tape condition, and the machine-side feeder setup. If the problem consistently follows the same feeder after these checks, the feeder itself becomes the next repair or replacement target.
There are two separate matching decisions. First, confirm X Smart rather than the older Hover-Davis 44mm SSF feeder family. Second, confirm whether the line uses the standard 00141375 configuration or the corresponding 00141395 Splice Sensor version. The same 44mm tape width does not make these feeder identities interchangeable.
00141375 44mm Feeder Specifications
| Part Number | 00141375 |
|---|---|
| Feeder Type | SIPLACE X Smart tape feeder |
| Assembly Level | Complete feeder |
| Tape Width | 44 mm |
| Feeder Family | SIPLACE X Smart |
| Splice Sensor Sibling | 00141395 |
Match the feeder system already installed on the production line. For quotation, provide the complete 00141375 label and suffix, exact machine model, tape pitch, component height or pocket requirement, whether Splice Sensor functionality is required, and clear photos of the installed feeder.
For 44mm positions that are difficult to substitute during production, keeping a correctly matched spare can reduce waiting while the operating feeder is being serviced. The key is to preserve the correct X Smart configuration rather than substitute a Hover-Davis SSF or another 44mm feeder family from width alone.